Using A Forklift To Move The Controller; Place Of Installation - YASKAWA NX100 Instructions Manual

3.2 Place of Installation

3.1.2

Using a Forklift to Move the Controller

Observe the following precautions when using a forklift to handle the controller:
• Confirm that there is a safe work environment and that the NX100 can be transported
safely to the installation site.
• Inform people along the forklift route that equipment is being moved in their area.
• Secure the controller so it cannot shift or fall during handling.
• Transport the controller at the lowest possible height.
• Avoid jarring, dropping, or hitting the controller during handling.
3.2
Place of Installation
The conditions listed below must be met before installing the NX100:
• Ambient temperature must be 0 to 45° C (32 to 113°F) during operation and -10 to 60°C
(14 to 140°F) during transportation and maintenance.
• Humidity must be low with no condensation (under 10%RH).
• It must be a place with little dirt, dust, or water.
• No flammable or corrosive liquids or gases, etc. in the area.
• Little jarring or potential for striking of the NX100 (under 0.5 oscillation).
• No large electric noise source (such as a TIG welding device, etc.) nearby.
• No potential for collision with moving equipment such as forklifts.
Protective padding
Tiedown straps
Palette
Forklift
3-2