YASKAWA NX100 Instructions Manual page 210

11.1 Addition of I/O Modules
Operation
5 Select {IO MODULE}.
6 Confirm the status of mounted
I/O module.
7 Press [ENTER].
The current status of the mounted I/O module is shown.
IO MODULE
ST# DI DO AI AO BOARD
00 0040 0040 -
01 0008 0008 002 002
02 - - -
03 - - -
04 - - -
05 - -
-
06 - - -
07 - - -
08 - - -
09 - - -
10 - - -
11 - - -
12 - - -
Main Menu Short Cut
Confirm that each station (ST#) window is the same as the I/O
module's actual mounting status.
The following information is shown for each station.
ST# Station address of I/O module
DI Number of contact input points ( *1 )
DO Number of contact output points ( *1 )
AI Number of analog input points ( *1 )
AO Number of analog output points ( *1 )
BOARD Circuit board type ( *2 )
*1
A hyphen, -, indicates that the corresponding I/O
section is not mounted.
*2
If the system cannot recognize the circuit board
type, a row of stars (*****) are
shown.
No problem will occur as long as the values dis-
played in DI, DO, AI, and AO are correct.
Confirm the statuses of the mounted I/O modules for the other
stations.
IO MODULE
ST# DI DO AI AO BOARD
05 - - -
06 - - -
07 - - -
08 - - -
09 - -
-
10 - - -
11 - - -
12 - - -
13 - - -
14 - - -
15 - - -
16 - - -
17 - - -
Main Menu Short Cut
11-2
Explanation
- NI001-02
XEW02
- NONE
- NONE
- NONE
- NONE
- NONE
- NONE
- NONE
- NONE
- NONE
- NONE
- NONE
Maintenance mode
- NONE
- NONE
- NONE
- NONE
- NONE
- NONE
- NONE
- NONE
- NONE
- NONE
- NONE
- NONE
- NONE
Maintenance mode