Show Nemo Status - Digi IX10 User Manual

Hide thumbs Also See for IX10:

Table of Contents

Virtual Private Networks (VPN)

a. Add a local network to use as a virtual NEMO network interface:

(config vpn nemo nemo_example)> add network end eth

(config vpn nemo nemo_example)>

b. (Optional) Repeat for additional interfaces.

14. Save the configuration and apply the change:

(config)> save

Configuration saved.

15. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Show NEMO status

1. Log into the IX10 WebUI as a user with Admin access.

2. On the menu, select Status > NEMO.

The NEMO page appears.

3. To view configuration details about an NEMO tunnel, click the  (configuration) icon in the

upper right of the tunnel's status pane.

Command line

1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10

local command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. To display details about all configured NEMO tunnels, type the following at the prompt:

3. To display details about a specific tunnel:

> show nemo name test

test NEMO Status

----------------

IX10 User Guide