Show Nemo Status - Digi IX10 User Manual

Virtual Private Networks (VPN)
12. Set the GRE tunnel local endpoint:
a. Set the method to determine the GRE tunnel local endpoint:
(config vpn nemo nemo_example)> tun_local type value
(config vpn nemo nemo_example)>
where value is one of:
n
n
The default is defaultroute.
13. Configure one or more local networks to use as a virtual NEMO network interface. Generally,
this will be a Local Area Network (LAN):
a. Add a local network to use as a virtual NEMO network interface:
(config vpn nemo nemo_example)> add network end eth
(config vpn nemo nemo_example)>
b. (Optional) Repeat for additional interfaces.
14. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
15. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show NEMO status


WebUI
1. Log into the IX10 WebUI as a user with Admin access.
2. On the menu, select Status > NEMO.
The NEMO page appears.
3. To view configuration details about an NEMO tunnel, click the  (configuration) icon in the
upper right of the tunnel's status pane.

Command line
IX10 User Guide
defaultroute: Uses the same network interface as the default route.
interface
If interface is used, set the interface.
i. Use the ? to determine available interfaces:
ii. Set the interface. For example:
(config vpn nemo nemo_example)> tun_local interface eth1
(config vpn nemo nemo_example)>
NEMO
254