Table of Contents
Advertisement
Virtual Private Networks (VPN)
13. Configure one or more local networks to use as a virtual NEMO network interface. Generally,
this will be a Local Area Network (LAN):
a. Add a local network to use as a virtual NEMO network interface:
(config vpn nemo nemo_example)> add network end eth2
(config vpn nemo nemo_example)>
b. (Optional) Repeat for additional interfaces.
14. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
15. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show NEMO status
WebUI
1. Log into the IX20 WebUI as a user with Admin access.
2. On the menu, select Status > NEMO.
The NEMO page appears.
3. To view configuration details about an NEMO tunnel, click the (configuration) icon in the
upper right of the tunnel's status pane.
Command line
1. Log into the IX20 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. To display details about all configured NEMO tunnels, type the following at the prompt:
> show nemo
NEMO
Enable
----
------
demo
false
test
true
>
3. To display details about a specific tunnel:
> show nemo name test
IX20 User Guide
Status
Address
Agent
------
-------
-------
up
1.2.3.4
4.3.2.1
CoAddress
----------
10.10.10.1
NEMO
395
Advertisement
Table of Contents
