Connect The Hardware To A Network; Connect Hardware And Connect To A Cellular Network; Connect Hardware And Connect To Site Network Using An Ethernet Lan - Digi Connect IT 4 User Manual

Hide thumbs Also See for Connect IT 4:

Table of Contents

Get started with Connect IT

Connect the hardware to a network

These sections explain how to connect to either a cellular network using the CORE module or to a site

network using an Ethernet cable.

Connect hardware and connect to a cellular network

This section explains how to connect the Connect IT hardware and then connect to a cellular network,

using a CORE module.

By default, the device uses a cellular network. As an alternative, you can also use an Ethernet

LAN connection. See

To connect the hardware and connect to the cellular network:

1. Insert a CORE module with an activated SIM card. See

2. Connect the power supply unit to the device.

3. Verify the cellular network signal strength indicator on the front of the Connect IT 4 shows two

or more bars for proper operation. See

Page break after

Connect hardware and connect to site network using an Ethernet

This section explains how to connect the Connect IT hardware and then connect to a site network,

using an Ethernet cable.

Prerequisites

CAT 5/6 Ethernet cable, which must be purchased separately.

To connect the hardware and connect to a site network:

1. Plug the power supply unit into an AC power outlet and connect the other end to the Power

plug on the Connect IT 4.

2. Connect one end of an Ethernet cable to your site gateway.

3. Connect the other end of the Ethernet cable to the Ethernet LAN port on the Connect IT 4.

Digi Connect IT® 4 User Guide

Connect hardware and connect to site network using an Ethernet

Connect the hardware to a network

Cellular ONLY: Insert the CORE