AttachNg A Tool; AttachNg A Cutter Plunger - GRAPHTEC CE6000-120AP User Manual

2.2
Attaching a Tool
Attach a tool (cutter plunger, plotter pen) to the plotter.
Attaching a cutter plunger
When mountng the cutter plunger n the tool holder, please note the followng.
•
Push the cutter plunger all the way into the holder until its flange contacts the upper part of the cutter holder
and then tighten the screw firmly.
•
To prevent njury; avod absolutely touchng the cutter plunger mmedately after the cuttng plotter s turned on
or whenever the cutter plunger s movng.
The cutter holder s sutable only for use wth the cutter plunger. Please refran from attachng the plottng pen to t.
Cutter holder
(Forward)
CAUTION
When pushing the cutter holder with your fingers, the blade tip may be protruding. Take care not to cut your fingers.
Supplement
Please make certan to set the cutter plunger of the cutter holder (forward).
Mounting
1
Loosen the cutter holder screw.
Bracket to hold tool
Pen holder
Top
Bracket to hold tool
Top
Ths cutter holder s
not set backward.
Pen holder
Cutter holder
Bracket to hold tool
2-4