Removing The Tool; Loading Media (Paper Or Marking Film); Loading Roll Media - GRAPHTEC CE6000 SERIES Setup Manual

3
Make sure that the tool bracket is engaged on the tool's flange, and then tighten the screw.

Removing the tool

When removing the tool, turn it counterclockwise to remove the tool.

2. Loading Media (Paper or Marking Film)

Both roll media and sheet media can be used with the CE6000.
Load the media according to the instructions given for each type. Use the grit roller on the right side of the media (looking
from the front) as a guide when setting it in the media sensor. Afterwards, adjust the push roller so that it's lined up with the
side of the media.
For details, see User's Manual (PDF).

Loading Roll Media

1
Lower the media set lever to raise the push rollers.
Media sensor
2
Set the roll media on top of the stock shaft, and then insert the roll media into the stopper. Once it's set, tighten the
stopper's screws.
Bracket to hold tool
Push roller
Flange
Media set
lever
Stopper
4
Supplement
For more information about the position of the
push roller, see "Adjust the Push Roller".