– Remove screw -2- for balancing shaft for inlet camshaft and
remove the balancing shaft.
Install
– Wet bearing of the balancing shaft -arrows- with engine oil.
– Install the balancing shaft for inlet camshaft and tighten the
screw -2-.
– Replace O-ring -1- and moisten with engine oil.
– Wet the bearing bolts with engine oil and enters the cylinder
block so that the fit pin -arrow-engages in the bore in the cyl‐
inder block.
Caution
♦ The intermediate shaft wheel must be replaced. Other‐
wise, the backlash cannot be adjusted - engine damage!
♦ The new intermediate shaft wheel has a smooth paint
covering which wears off after a short running time, and
thus automatically sets the backlash.
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
69
4. Balancing shafts