Install Ball For Camshaft Slide - Skoda Octavia III 2013 Workshop Manual

– Unscrew the assembly tool - T10531/4- and remove assembly
tool - T10531/3- .
– Install below cover for timing chain
Note
Do not tighten screws -1- and -4- until the V-ribbed belt pulley has
been installed. Before installing the belt pulley, remove the screws
again.
– Installing the V-ribbed belt pulley crankshaft
– Install top cover for timing chain
– Install tensioner pulley for V-ribbed belt
– Install the V-ribbed belt
– Installing the vacuum pump ⇒ Suspension; Rep. gr. 47 .
– Install high pressure pump
Further installation occurs in reverse order. However, pay atten‐
tion to the following:
Carry out an adjustment of the timing chain length as follows:
– Switch on ignition and ⇒ Vehicle diagnostic tester connect.
– On the display press consecutively the following buttons:
♦
01 - Engine electronics
♦
01 - Targeted functions
♦
01 - Basic setting
♦
01 - Adaption after work on chain drive
Tightening torques:
♦ Camshaft timing shaft - Summary of components
♦ Balancing shaft timing chain- Summary of components
⇒ page 101
♦ Valve gear - Summary of components
♦ Summary of components - air filter
♦ Summary of components - high pressure pump
♦ Noise insulation ⇒ Body Work- Assembly; Rep. gr. 50
4.5

Install ball for camshaft slide

Special tools and workshop equipment required
♦ Spacer - T40191/1-
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
⇒ page 85 .
⇒ page 49
⇒ page 82 .
⇒ page 47
⇒ page 45 .
⇒ page 316 .
⇒ page 120
⇒ page 287
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
.
⇒ page 90
⇒ page 314
147
4. Valve gear