Skoda Octavia III 2013 Workshop Manual page 309

– Push sleeve -T10133/18- over the injection valve.
– Carefully tap on sleeve several times to loosen the injection
valve.
Note
Use a torque wrench to pull out the injector.
♦
Set 5 Nm on the torque wrench.
♦
– Insert extractor -T10133/2A- into the groove of the injection
valve.
– Afterwards, attach the extractor T10133/16A .
– Remove the injection valve by turning the screw with a torque
wrench -1-.
– If the limit torque of 5 Nm is reached without the injector loos‐
ening, remove the extractor and begin to loosen the injector
again using the hitting it.
Note
Failure to observe the torque threatens the destruction of the
♦
injector.
The combustion chamber sealing ring must always be re‐
♦
placed before the injection valve is pre-installed.
– After disassembly, replace the combustion chamber sealing
ring and install the injection valve
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
⇒ page 302 .
Octavia III 2013 ➤ , Octavia III 2014 ➤
301
4. Injection valves