Skoda Octavia III 2013 Workshop Manual page 92

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
– Remove screws in sequence -6 to 1- and remove top cover for
timing chain.
– Remove screws -3, 5- as required.
Install
Installation is carried out in the reverse order. However, pay at‐
tention to the following:
• Tightening torques ⇒ page 81
Note
Replace gasket rings after disassembly
WARNING
Risk of contamination of the lubrication system by sealant res‐
idues.
♦ Place clean cloths over the open part of the oil sump.
– Remove the residual sealant from the bearing cap.
– Clean oil and grease from sealing surfaces.
Note
Pay attention to the use by date on sealant.
– Cut off nozzle on tube at front marking (∅ of nozzle approx.
1.5 mm).
WARNING
Risk of blockage of the lubrication system through excess seal‐
ant.
♦ The sealant bead must not be thicker than specified.
– Apply sealant beads to the clean sealing surfaces as shown
-arrows-.
• Thickness of sealant bead: 2 mm
Note
The top cover for the timing chain must be installed within 5 mi‐
nutes after applying the sealant.
– Install top cover for timing chain.
84
Rep. gr.15 - Cylinder head, valve gear