– Loosen and remove screws for cylinder head cover in the se‐
quence -1 ... 6-.
– Remove cylinder head cover.
– Take out camshafts.
WARNING
Risk of contamination to the hinge system and bearings.
♦ Cover opened engine parts.
Install camshafts
Note
Make sure that all roller rocker fingers correctly rest on the end
♦
of the valve stem.
The pistons must not be positioned at top dead centre.
♦
– Remove residual sealant on the cylinder head and camshaft
housing using a chemical sealant remover.
– Clean oil and grease from sealing surfaces.
– Oil contact surfaces of camshafts.
– Engage inlet camshaft -A- in the cylinder head. Turn the cam
on cylinder 4 -arrows- upwards.
– Insert the exhaust camshaft into the cylinder head cover, as
shown in the figure. The cam pair -A and B- must settle to‐
wards each other.
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
141
4. Valve gear