– Apply silicone sealant ⇒ ETKA - Electronic Catalogue of Orig‐
inal Parts -arrow-, as shown in the figure, to the clean sealing
surface of the sealing flange on the gearbox side.
♦ Thickness of sealant bead: 2 ... 3 mm
– Fit guide bushing - T20097- onto the crankshaft journal -A-.
– Slide sealing flange over the guide bushing - T20097- onto the
crankshaft stub.
Note
The sealing flange on the gearbox side must be installed within
♦
5 minutes after applying the silicone sealant.
The sealant bead must not be thicker than specified otherwise
♦
excess sealant may get into the oil pan and clog the strainer
in the oil suction pipe.
– Immediately place the sealing flange on the gearbox side and
tighten the screws in the sequence shown, as follows.
– Tighten screws in 2 steps in the given sequence:
Stage
Screws
1.
-1...8-
2.
-1...8-
Further installation occurs in reverse order.
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
Tightening torque
by hand as far as the stop
9 Nm
Octavia III 2013 ➤ , Octavia III 2014 ➤
2. Cylinder block - gearbox end
59