Skoda Octavia III 2013 Workshop Manual page 140

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
– Apply silicone sealant to the clean sealing surface of the oil
pan, as shown arrows -arrows-.
♦ Thickness of sealant bead: 2...3 mm.
Note
The cylinder head cover must be installed within 5 minutes
♦
after applying the silicone sealant.
The sealant bead must not be thicker than specified otherwise
♦
excess sealant may get into the oil pan and clog the strainer
in the oil suction pipe.
Pay attention to the use by date on sealant.
♦
Sealant ⇒ ETKA - Electronic Catalogue of Original Parts.
Note
Do not remove or move the slide, it is an element of the camshaft
⇒ page 147
– Place cylinder head cover with exhaust camshaft -1- on the
cylinder head.
– Using the hand, lightly press on the cylinder head cover, while
doing so, lightly turn the camshaft so that the cover sits onto
the cylinder head tension-free.
– After disassembly, replace cylinder head cover screws.
– Tighten screws in several stages, tightening sequence
⇒ page 122 .
Note
Make sure that the cylinder head cover is not tilted.
132
Rep. gr.15 - Cylinder head, valve gear