Removing And Installing Fuel Tank For Vehicles With Front-Wheel Drive; Removing And Installing Fuel Tank For Vehicles With Front- Wheel Drive - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
– Removing rear seat bench ⇒ Body Work; Rep. gr. 72 .
– Unclip the cover -1- using the disassembly wedge - 3409- .
Vehicles with auxiliary heating
– Disconnect the dosing pump - V54- -2- 2-pin plug connection.
Continued for all vehicles
– Disconnect the 5-pin plug connection -1- and the black feed
line ⇒ page 250 .
– Connect the adapter -V.A.G 1318/16- with the adapter -V.A.G
1318/17- and fit this "drain pipe" thus prepared onto the feed
support of the fuel delivery unit.
– Hold the "drain pipe" in a suitable fuel tank.
– Connect the battery and the contacts of the fuel pump with
adapter cables -A- from the adapter cable set - V.A.G 1594/
C- as follows:
Battery positive terminal (+) to contact -1- of the fuel pump
Battery negative terminal (-) to contact -5- of fuel pump
The fuel pump runs and suctions off fuel.
WARNING
In order to prevent an overflow of fuel in case of a too small
fuel tank, the fuel pump must not run unattended.
1.4 Removing and installing fuel tank for ve‐
hicles with front-wheel drive
Special tools and workshop equipment required
♦ Engine and gearbox jack , e.g. -V.A.G 1383 A-
♦ Disassembly wedge - 3409-
• The fuel tank must be empty for weight reasons when remov‐
ing it, if necessary suction the fuel out of the fuel tank
⇒ page 221 .
222
Rep. gr.20 - Fuel supply system