Skoda Octavia III 2013 Workshop Manual page 59

– Screw the assembly tool - T10531/2- into the crankshaft and
tighten using the SW12 -A- wrench.
– Tighten the clamping screw -A- by hand. As a result, the chain
sprocket is secured to the crankshaft.
– Screw out the knurled screws -arrows-, remove the assembly
tool - T10531/1- as well as the V-ribbed belt pulley -A-.
If the crankshaft turns without the belt pulley:
– Slide the assembly tool - T10531/3- onto the assembly tool -
T10531/2- - when doing so, pay attention to the tooth contour
of the chain sprocket. The flattened part of the assembly tool
must be upright in the TCD position.
– Tighten assembly tool - T10531/3- and assembly tool -
T10531/4- .
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
1. Cylinder block - Belt pulley side
51