Skoda Octavia III 2013 Workshop Manual page 144

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
Removing
Note
The sealing surfaces of the lower cylinder head cover and the
♦
top cylinder head must not be reworked.
The camshaft bearings are integrated in the cylinder head/
♦
cylinder head cover. Before removing of the cylinder head
cover, the camshaft timing shaft must be relieved.
Fit all cable straps on again in the same place when installing.
♦
– Remove air filter housing
– Remove top coolant pipe
– Removing ignition coils
– Disconnect the plug connections:
1 - for turbocharger divert air valve - N249-
2 - for hall sender 3 - G300-
3 - for fuel pressure regulating valve - N276-
– Disconnect connectors -arrows- from the positioning elements
for camshaft adjustment.
– Release screw -5- and battery earth strap.
– Undo the electric wiring harness from the clip -4- and swivel
out towards the front.
– Unlock the catches -arrow-, remove the wiring guide upwards
out of the bracket and push forwards.
WARNING
Risk of damaging the coolant lines.
♦ Do not change the bending form of the coolant pipes.
– Undo the screws -1, 2 and 3- and swivel the coolant pipe to
the rear a little carefully.
– Disconnect connectors -1- from activated charcoal filter sole‐
noid valves 1 - N80- .
– Press release buttons on the hose -2- for crankcase ventilation
and remove from cylinder head cover.
– Release screws-arrows- and remove holder.
136
Rep. gr.15 - Cylinder head, valve gear
⇒ page 288 .
⇒ page 207 .
⇒ page 342 .