Removing And Installing Middle And Rear Part Of The Exhaust System - Skoda Octavia III 2013 Workshop Manual

– Unscrew the screw -4- and remove the middle part of the ex‐
haust system -1-.
Replace rear part of the exhaust system
– Unhook the retaining strap -2- on the rear part of the exhaust
system.
– Unscrew the screw -3- and remove the rear part of the exhaust
system.
Install
Installation is carried out in the reverse order. However, pay at‐
tention to the following:
• Tightening torques ⇒ page 332
– When installing, position rear clamping sleeve -4- at the side
markings -arrow 1- and -arrow 3-.
– Turn rear clamping sleeve -4- in such a way that the ends of
the screws -arrow- do not protrude beyond the bottom edge of
the clamping sleeve.
– Tighten bolted connections of clamping sleeve evenly to 23
Nm.
– Align exhaust system free of stress
1.7 Removing and installing middle and rear
part of the exhaust system
For vehicles with engine identification characters CJSB and
CHHB
Removing
– Remove the rear left underfloor trim panel ⇒ Body Work; Rep.
gr. 66 .
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
.
⇒ page 339 .
1. Removing and installing parts of the exhaust system
Octavia III 2013 ➤ , Octavia III 2014 ➤
337