Skoda Octavia III 2013 Workshop Manual page 263

– Tilt the cover for underbody -1- towards the front in
-direction of arrow-.
– Disconnect electrical plug connections -2- on the accelerator
pedal module, thereby pressing the release upwards.
– Unscrew screw -1-.
– Remove accelerator module -3- from the uptake.
Install
Installation is carried out in the reverse order. However, pay at‐
tention to the following:
– If the accelerator pedal module was replaced on vehicles with
automatic gearbox, the engine control unit must be adapted
⇒ Vehicle diagnostic tester.
Caution
Risk of damage to knee airbag surface by mechanical stress.
After completion of the visual inspection, check that the knee
airbag surface is not damaged.
3.2.1 Disconnect connector for accelerator
pedal module and fit on
Note
The plugs for the accelerator pedal module which are inserted,
must be disconnected and fit on in a different manner.
Disconnect connector 1K0 973 706
– Slightly press the piston slide valve -A- (grey) in
-direction of arrow 1- and push it up to the stop in
-direction of arrow 2-.
– Hold the piston slide valve in this position and disconnect the
socket housing -B- towards the top in -direction of arrow 3-.
The piston slide valve -A- remains in the bottom position.
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
255
3. Accelerator pedal