Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
Installation position of front clamp
– Install clamping sleeve in the position shown.
•
Angle -α- = approximately 20°.
•
bolted connection points to the right.
•
Nuts point upwards.
Fitting position of fixing clamp for turbocharger/catalytic converter
•
Angle -α- = 30°.
Catalytic converter- tightening torque and tightening order
– Tighten all screw fittings step by step in the given sequence:
Stage Fixing clamp/nut Tightening torque
1.
-1, 3, 4-
2.
-2-
3.
-1, 3, 4-
1.2
Removing and installing exhaust pipe
Note
The catalytic converter is remove with the pre-exhaust pipe.
Special tools and workshop equipment required
♦ Hot bolt paste ⇒ ETKA - Electronic Catalogue of Original Parts
328
Rep. gr.26 - Exhaust system
by hand as far as the stop
•
It must still be possible to move the
catalytic converter and the bracket
Tighten fixing clamp to 15 Nm.
tighten to 20 Nm