Skoda Octavia III 2013 Workshop Manual page 39

– Initially insert screws -arrows- for gearbox mount by hand as
far as the stop.
Note
Do not tighten the screws fully until the assembly bracket has
been adjusted.
– Remove engine mount - T10359- from engine.
– Install drive shafts ⇒ Chassis; Rep. gr. 40 .
Vehicles fitted with a manual gearbox
– Install slave cylinder ⇒ Gearbox; Rep. gr. 30 .
– Install linkages with cable support ⇒ Gearbox; Rep. gr. 34 .
Vehicles with automatic gearbox
– Install and adjust the selector lever linkage ⇒ Gearbox; Rep.
gr. 34 .
Vehicles with four-wheel drive
– Install propshaft on the angle gearbox ⇒ Rear final drive; Rep.
gr. 39 .
Continued for all vehicles
– Install exhaust pipe with catalytic converter
– Install AC compressor ⇒ Air Conditioning; Rep. gr. 87 .
– Install poly V-belt ⇒ page 45
– Adjust the assembly bracket
– Remove battery tray ⇒ Electrical System; Rep. gr. 27 .
– Electrical connections and proper routing ⇒ Electrical System;
Rep. gr. 97 and ⇒ Current flow diagrams, Electrical fault find‐
ing and Fitting locations.
– Install air filter housing
– Install the battery and pay attention to the necessary work after
re-connecting the battery ⇒ Electrical System; Rep. gr. 27 .
– Checking the oil level ⇒ Maintenance ; Booklet Octavia III .
WARNING
Risk of damaging control units as a result of overvoltage.
♦ Do not use charger for jump starting!
– Connect coolant hoses with quick coupling to the heat ex‐
changer for the heating system
– Replenish coolant ⇒ page 183
Note
Only re-use drained coolant if the cylinder head or cylinder
♦
block has not been replaced.
Dirty coolant must not be used again.
♦
– Install the assembly carrier ⇒ Chassis; Rep. gr. 40 .
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
⇒ page 328
.
⇒ page 41 .
⇒ page 288 .
⇒ page 210 .
.
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
2. Removing and installing engine
31