Skoda Octavia III 2013 Workshop Manual page 69

1 - Cylinder block
❑ if the cylinder block is re‐
placed, the bearing
shells in the cylinder
block will need to be re-
assigned ⇒ page 63
2 - Bearing shell
❑ in cylinder block
❑ with lubricating groove
❑ do not mix up already
used bearing shells
(mark)
❑ Identification
⇒ page 63
❑ moisten with oil
3 - Crankshaft
❑ New axial clearance:
0.07 ... 0.23 mm
Wear limit: 0.30 mm
❑ Crankshaft bearing jour‐
nals
♦ 1.8 l engines: ∅ 48.00 mm
♦ 2.0 l engines: ∅ 52.00 mm
❑ Rod bearing journals: ∅
47.80 mm
❑ install the crankshaft af‐
ter removal so that the
sensor rotor -Pos. 8-
dos not rest or is dam‐
aged.
❑ if the crankshaft is re‐
placed, the bearing
shells for the bearing
covers will need to be
re-assigned ⇒ page 63
❑ A needle bearing is installed in vehicles with automatic gearbox
❑ Pulling out and driving in the needle bearing for crankshaft
4 - Bearing shell
❑ in bearing cap
❑ without lubricating groove
❑ do not mix up already used bearing shells (mark)
❑ Identification ⇒ page 63
❑ moisten with oil
5 - Screw
❑ Replace after disassembly
❑ order of tightening
6 - Bearing caps
❑ Bearing cover 1: Belt pulley side
❑ retaining lugs of the bearing shells of the cylinder block/bearing cap must be on top of one another
7 - Screw
❑ Replace after disassembly
❑ Replace sensor rotor each time the bolts are slackened
❑ 10 Nm + torque a further 90° (
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
⇒ page 62
1
/ 4 turn)
Octavia III 2013 ➤ , Octavia III 2014 ➤
⇒ page 64
61
3. Crankshaft