Removing And Installing Control Valve For Piston Cooling Nozzles N522 - Skoda Octavia III 2013 Workshop Manual

8 - Oil pressure switch - F1-
❑ blue
❑ check ⇒ Vehicle diagnostic tester
❑ Removing and installing
❑ 20 Nm
9 - Oil pressure switch for reduced oil pressure - F378-
❑ Brown
❑ check ⇒ Vehicle diagnostic tester
❑ Removing and installing
❑ 20 Nm
10 - Sealing ring
❑ Replace after disassembly
11 - Sealing ring
❑ Replace after disassembly
12 - Oil pressure switch, stage 3 - F447-
❑ check ⇒ Vehicle diagnostic tester
❑ Removing and installing
❑ 20 Nm
4.2 Removing and installing control valve
for piston cooling nozzles - N522-
Removing
Note
Place cloths under bracket for auxiliary units to catch escaping
coolant.
– Remove connector -arrow- from the control valve for piston
cooling nozzles - N522- .
– Unscrew the screw -1- and remove the control valve for piston
cooling nozzles - N522- -2-.
Install
Installation is carried out in the reverse order. However, pay at‐
tention to the following:
• Tightening torques ⇒ page 172
Note
Replace O-rings.
♦
To prevent oil loss, immediately screw in a new control valve
♦
for piston cooling nozzles - N522- into the bore hole.
– Check the engine oil level ⇒ Maintenance ; Booklet Octavia
III .
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
⇒ page 174
⇒ page 174
⇒ page 175
Octavia III 2013 ➤ , Octavia III 2014 ➤
4. Oil pressure switch
173