Removing And Installing Engine Noise Speaker - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
– Unlock catch in -direction of arrow A- and remove the engine
control unit -arrow B-.
– Unlock plug connections for engine control unit - J623- and
pull off.
Install
Installation is carried out in the reverse order. However, pay at‐
tention to the following:
– Insert the engine control unit with the lower edge towards the
front -arrow A-.
• The bridge of the engine control unit - J623- must engage in
the recess -arrow B- top and bottom.
– It is imperative for the protective housing to be put back in
place on the engine control unit - J623- .
– Clean the threaded holes for the shear bolts to remove safety
agent residues. Cleaning can be done using a tapper.
– Use new shear bolts.
After installing a new engine control unit, the following work step
must be performed:
– Control the engine control unit - J623- as follows:
– Switch on ignition and ⇒ Vehicle diagnostic tester connect.
– On the display press consecutively the following buttons:
♦
01 - Engine electronics
♦
01 - Targeted functions
♦
01 - Basic setting
♦
01 - Replace the engine control unit
8.3 Removing and installing engine noise
speaker
Removing
– Removing plenum chamber cover and then bulkhead plenum
chamber ⇒ Body Work; Rep. gr. 50 .
324
Rep. gr.24 - Mixture preparation - injection