Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
Removing
– Remove connector -1- from the Lambda probe after catalytic
converter - G130- .
– Unscrew lambda probe after catalytic converter - G130- -1- out
of the Lambda probe open ring spanner set - 3337- with a tool.
Install
When installing, pay attention to the following points:
Note
The threads on new lambda probes are coated with assembly
♦
paste. This paste must not come into contact with the slots of
the lambda probe body.
For a re-used lambda probe, only coat the thread with hot bolt
♦
paste. This paste must not come into contact with the slots of
the lambda probe body. Hot bolt paste ⇒ ETKA - Electronic
Catalogue of Original Parts .
The electrical cable wire connection of the lambda probe must
♦
be secured at the same points during reinstallation. Contact
between the electrical cable connection and the front exhaust
pipe must be prevented.
•
Tightening torque
⇒ page 318
320
Rep. gr.24 - Mixture preparation - injection
.