Removing And Installing Engine Oil Cooler - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
❑ Moisten with coolant
13 - Connecting studs
14 - Screw
❑ Replace after disassembly
❑ 8 Nm + torque a further 45° (
15 - Screw
❑ Tightening torque and tightening order
2.2 Removing and installing engine oil cool‐
er
Special tools and workshop equipment required
♦ Catch pan , e.g. -VAS 6208-
Removing
WARNING
Danger of scalding due to hot steam and hot coolant.
♦ When the engine is warm, the cooling system is under
pressure.
♦ Cover the cap on the coolant expansion tank with a cloth
and open carefully.
– Drain coolant ⇒ page 182
– Remove the bracket for auxiliary units
– Unscrew screws -4-, -5- and remove the engine oil cooler -3-
with seal -2-.
Install
Installation is carried out in the reverse order. However, pay at‐
tention to the following:
• Tightening torques
⇒ "2.1 Bracket for auxiliary units with oil filter and engine oil
cooler - Summary of components", page 167
Note
Renew gaskets and seals.
♦
Secure all hose connections with hose clamps which comply
♦
with the series design ETKA - ⇒ Electronic Catalogue of Orig‐
inal Parts .
168
Rep. gr.17 - Lubrication
1
/ 8 turn)
⇒ page 45
.
⇒ page 47
.