Skoda Octavia III 2013 Workshop Manual page 50

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
– Release the catch -arrow-, remove engine trim panel mount
-1-.
– Remove battery and battery tray -1- ⇒ Electrical system; Rep.
gr. 27 .
– Remove caps of the screw connections of the front suspension
strut dome.
– Fit adapter - MP9-200/18 - with hook - MP9-200/10 - onto the
support bracket - T30099- with the support - 10-222A/31- .
– Attach the supporting device - T30099- with support -
10-222A/31- and base - T30119- to the screw fittings of the
suspension strut dome as shown.
– Uniformly pre-tension the engine/gearbox unit with spindles,
but do not raise.
– Unscrew screws -arrows- for engine mount one after another
and replace (if not already done during engine installation).
– Firstly, loosely insert the screws.
– Move engine/gearbox unit with an assembly lever until the fol‐
lowing dimensions are set:
• A distance of -a- = 10 mm must be present between engine
support -1- and engine mount.
• The cast edge on the engine support must be parallel with the
engine mount supporting arm.
• Dimension -b- = dimension -b-.
Note
The distance -a- = 10 mm can be checked e.g. with suitable round
bars.
– Tighten screws for engine mount.
42
Rep. gr.10 - Removing and installing engine