Removing And Installing Bottom Cover For Timing Chain - Skoda Octavia III 2013 Workshop Manual

Tightening sequence for top cover for timing chain
– Tighten screws -1 to 6- in the order shown:
– Tighten screws to 9 Nm.
– Install camshaft control valve 1 - N205- and Camshaft control
valve 1 in the exhaust - N318-
1.4 Removing and installing bottom cover
for timing chain
Special tools and workshop equipment required
♦ Thrust piece - T10368-
♦ Protective goggles
♦ Protective gloves
♦ Cleaning and degreasing agent , e.g. -D 009 401 04-
♦ Sealant remover gasket stripper (bearing code GST, bearing
article no. R 34402), manufacturer Retech s.r.o.
♦ Sealant ⇒ ETKA - Electronic Catalogue of Original Parts.
Removing
– Remove the front right wheelhouse liner ⇒ Body Work; Rep.
gr. 66 .
– Drain engine oil ⇒ Maintenance ; Booklet Octavia III .
– Remove engine support
– Disconnect plug connections -1- from valves for oil pressure
control - N428- .
– Remove tensioning pulley for V-ribbed belt
– Remove poly V-belt pulley from crankshaft
– Undo the retaining clip -arrow- on the electric wire harness.
– Unscrew screw -1-.
– Undo guide pipe for dipstick from the mount on the top cover
for the timing chain -arrow-.
– Remove the guide pipe for dipstick from the cover for the tim‐
ing chain.
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
⇒ page 82 .
⇒ page 37 .
⇒ page 47
⇒ page 49
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
.
1. Covers for timing chains
85