Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
Note
If the high-pressure system is not opened immediately the
♦
pressure increases again as a result of the reheating effect.
The ignition system must no longer be switched on, since oth‐
♦
erwise the pressure will increase again.
Interrogate the event memory of the engine control unit at the
♦
end of the following work and delete all the event memory en‐
tries.
The readiness code must be generated if the event memory
♦
has been cleared ⇒ Vehicle diagnostic tester.
1.2.3
Safety measures for working on vehi‐
cles with start/stop system
When working on vehicles with start/stop system, please observe
the following:
WARNING
There is risk of injury from automatic engine starting on vehi‐
cles with start/stop system.
♦ In vehicles with an activated start-stop system (indicated
by a message in the dash panel insert), the engine can
start automatically if necessary.
♦ It is therefore necessary to ensure that the start-stop sys‐
tem is deactivated when carrying out work on the vehicle
(switch ignition off, if required switch ignition on again).
1.2.4
Safety precautions during road tests in
which testing and measuring equipment
is used
WARNING
There is a risk of accident from deflection and insufficient se‐
curing of testers and measuring instruments.
There is also a hazard from the release of the passenger airbag
in the event of an accident.
• Using testers and measuring instruments during driving
operation creates a risk of deflection.
• Increased risk of injury from unsecured testers and meas‐
uring instruments must be prevented.
♦ Testers and measuring instruments must always be se‐
cured on the rear seat using a seat belt and by a 2nd
person on the rear seat.
4
Rep. gr.00 - Technical data