Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
– Loosen and remove screws for cylinder head cover in the se‐
quence -1 ... 6-.
– Remove cylinder head cover.
– Take out camshafts.
Note
Do not remove and do not move the slide, which is an element of
the camshaft
⇒ page 147
WARNING
Risk of contamination to the hinge system and bearings.
♦ Cover opened engine parts.
Install
Note
Make sure that all roller rocker fingers correctly rest on the end
♦
of the valve stem.
The pistons must not be positioned at top dead centre.
♦
WARNING
Risk of injury to eyes.
♦ Wear safety goggles!
WARNING
Risk of contamination to the hinge system and bearings.
♦ Cover opened engine parts.
– Remove residual sealant on the cylinder head and camshaft
housing using a chemical sealant remover.
– Clean oil and grease from sealing surfaces.
– Oil contact surfaces of camshafts.
– When replacing the camshafts, the marks -arrow- must be
transferred to the new camshafts.
WARNING
Avoid damage to valves and piston crowns.
♦ When the camshaft timing shaft was removed from the
cylinder head, the crankshaft must not be turned further.
130
Rep. gr.15 - Cylinder head, valve gear
.