Replacing Gasket Ring For Crankshaft -On The Belt Pulley Side - Skoda Octavia III 2013 Workshop Manual

1.5 Replacing gasket ring for crankshaft -on
the belt pulley side-
Special tools and workshop equipment required
♦ Thrust piece - T10354-
♦ Thrust piece - T10368-
♦ Puller hooks - T40274-
♦ Assembly tool - T10531/4-
Removing
– Remove poly V-belt pulley from crankshaft
– Remove gasket ring -arrow- with extractor hook - T40274- out
of the timing case.
Install
– Clean the bottom cover for the timing chain in the area of the
seal fitting. it must be free of oil and grease.
Note
Always use a new gasket ring. Moisten with oil before the as‐
sembly.
– Insert the gasket ring -arrow- with thrust piece - T10354- into
the timing case.
– Push on the thrust piece - T10368- and tighten the assembly
tool - T10531/4- as far as it can go.
– Remove the assembly tool - T10531/4- , thrust piece - T10368-
and thrust piece - T10354- .
– Installing the V-ribbed belt pulley crankshaft
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
⇒ page 49 .
⇒ page 49 .
1. Covers for timing chains
89