Removing And Installing Coolant Temperature Sender At Radiator Outlet G83; Coolant Pump And Positioning Element For Engine Temperature Control - Skoda Octavia III 2013 Workshop Manual

– Unplug connector -1-.
Note
Place a cloth below to absorb leaking coolant.
♦
To prevent losing too much coolant, insert the new coolant
♦
temperature sender - G62- into the connection fitting right
away.
– Unscrew the screw -2- and remove the coolant temperature
sender - G62- -3-.
Install
Installation is carried out in the reverse order. However, pay at‐
tention to the following:
Note
Replace O-rings.
– Check coolant level
2.12 Removing and installing coolant temper‐
ature sender at radiator outlet - G83-
Removing
• Engine cold
– To release the residual pressure in the cooling system, briefly
open the screw cap -arrow- on the coolant expansion tank,
and seal it until it latches into position.
– Remove the sound dampening system ⇒ Body Work; Rep.
gr. 50 .
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
⇒ page 183 .

2. Coolant pump and positioning element for engine temperature control

Octavia III 2013 ➤ , Octavia III 2014 ➤
203