Skoda Octavia III 2013 Workshop Manual page 94

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
Cover with 8 screws
– Unscrew screws in sequence -8...1-.
Cover with 15 screws
– Unscrew screws in sequence -15...1-.
For all versions
– Cut through the sealant with a sharp flat spatula at the acces‐
sible places all the way around the bottom cover for the timing
chain.
– Carefully, and in stages, pry open the bottom cover for timing
chain with a spatula to prevent it from being deformed.
Install
Note
Silicone sealant: ⇒ ETKA - electronic Catalogue of Original
♦
Parts .
Pay attention to the use by date on silicone sealant.
♦
The bottom cover for the timing chain must be installed within
♦
5 minutes after applying the sealant.
After disassembly, replace the screws which were tightened
♦
with the torquing angle.
Replace the gaskets, sealing rings and self-locking nuts.
♦
WARNING
Wear protective gloves when working with sealant and grease
remover!
– Remove residual sealant from the sealing surfaces on the cyl‐
inder block, upper part of the oil pan, and on the bottom cover
with chemical sealant remover.
– Degrease the sealing surfaces.
86
Rep. gr.15 - Cylinder head, valve gear