Removing And Installing The Sender For Fuel Gauge Display G - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
– Insert lock ring and tighten using the wrench - T30101 (3087)- .
– Connect fuel lines ⇒ page 250
Vehicles fitted with auxiliary heating
– If the fuel delivery unit was replaced, disconnect the cover
-7- from the removal connection -6- at the marked separation
point and insert the standpipe -3- into the space -4- until the
reinforcement rests against the removal connection -6-.
– Push sleeve -2- on and secure with clamps -1-.
Note
Switch on the auxiliary heating and run it for at least 10 minutes
at full load to ensure the complete discharge of the fuel line.
Continued for all vehicles
– After installing the fuel delivery unit, refuel with at least 5 litres
of fuel.
1.10 Removing and installing the sender for
fuel gauge display - G-
Removing
– Observe safety instructions
– Observe rules for cleanliness
– Remove fuel delivery unit
– Disconnect plug connections -1- on the closing flange, thereby
unlocking the plug lock.
– Unhook the electric cable from the holder -arrow- and expose
it.
– Unlock catches on uptake clamps -3 and 4- and at the same
time pull the sender for fuel gauge display - G- -2- upwards.
For vehicles with four-wheel drive
Remove fuel delivery unit
240
Rep. gr.20 - Fuel supply system
.
⇒ page 2 .
⇒ page 9 .
⇒ page 233 .
⇒ page 236 .