Skoda Octavia III 2013 Workshop Manual page 124

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
– Remove bolts -arrows-.
– Unscrew cylinder head bolt with Polydrive socket - T10070- in
the order -1...10-.
Note
Check whether all lines and cables have been loosened!
♦
When removing the cylinder head, pay attention to the ten‐
♦
sioning and guide rail.
– Remove cylinder head.
– Place the cylinder head on a clean base (foam).
Install
WARNING
Risk of damaging sealing surfaces.
♦ Carefully remove residual sealant from the cylinder head
and cylinder block.
♦ Make sure this does not cause any extended scoring or
scratching.
Risk of damaging the cylinder block.
♦ There must be no oil or coolant in the blind holes for the
cylinder head bolts in the cylinder block.
Danger of leaks from the cylinder head gasket.
♦ Remove the new cylinder head gasket from its wrapping
immediately before fitting.
♦ To prevent the silicon layer and the area of the bead from
being damaged, handle the gasket with the utmost care.
Risk of damage to the open valves.
♦ The plastic packing pieces for protecting the open valves
when installing the exchange cylinder head must not be
removed until immediately before fitting the cylinder head.
Risk of damaging valves and piston crowns after work on the
valve gear.
♦ Carefully crank engine at least 2 revolutions to ensure that
no valve touches the piston when the engine is started.
116
Rep. gr.15 - Cylinder head, valve gear