Skoda Octavia III 2013 Workshop Manual page 16

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
Caution
In case a mechanical damage to the exhaust gas turbocharger
is found, e.g. damage to the compressor wheel, it is not suffi‐
cient to only replace the turbocharger. In order to avoid con‐
sequential damage, perform the following tasks:
♦ Clean all oil lines.
♦ Change engine oil and oil filter.
♦ Inspect the air filter housing, the air filter element and the
intake hoses for contaminations.
♦ Inspect the whole charge-air routing and the charge air
cooler for foreign bodies.
If foreign bodies are detected in the charge air system, the
complete charge-air routing must be cleaned and if necessary
the charge air cooler must also be replaced.
♦ The charge-air system must be tight.
♦ Renew self-locking nuts.
♦ Hose connections and hoses of the charge air system must
be free of oil and grease before being installed.
♦ Only use approved clamps for securing the hose connections
⇒ Electronic Catalogue of Original Parts"ETKA" .
♦ Spring-type clip pliers are recommended for installation of
spring-type clips.
♦ Before connecting the oil feed line, fill the exhaust turbocharg‐
er via the connection fitting with engine oil.
♦ After installing the turbocharger, run engine at idling speed for
about 1 minute to ensure that oil is supplied to the turbocharg‐
er.
1.2.12 Additional instructions when undertak‐
ing assembly work on the air-condition‐
ing system
WARNING
Do not open the refrigerant circuit of the air conditioning sys‐
tem.
Note
To prevent damage to condenser or to refrigerant lines/hoses,
ensure that the lines and hoses are not stretched, kinked or bent.
Steps which should be taken in order to remove and install the
engine without opening the refrigerant circuit:
– Remove the holding clamp(s) of the refrigerant lines.
– Remove AC compressor ⇒ Heating, Air Conditioning; Rep.
gr. 87 .
– Mount the AC compressor in such a way that the refrigerant
lines/hoses are not under tension.
8
Rep. gr.00 - Technical data