Skoda Octavia III 2013 Workshop Manual page 38

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
– If not present in the cylinder block, insert dowel sleeves -A- to
centre the engine/gearbox.
Vehicles fitted with a manual gearbox
• If a needle bearing is installed in the crankshaft, the needle
bearing must be removed
• If the clutch release bearing is worn, it will need to be replaced
⇒ 30; Rep. gr. Getriebe .
– Evenly lubricate the teething on the input shaft with grease ⇒
ETKA Electronic Catalogue of Original Parts .
– Check the centering of the driver clutch.
Vehicles with automatic gearbox
– If no needle bearing is installed in the crankshaft, install it
⇒ page 64 .
Vehicles with four-wheel drive
– Install the bracket for angle gearbox ⇒ 39; Rep. gr. Getriebe .
Continued for all vehicles
– Secure gearbox to engine.
– Install the starter motor ⇒ Electrical System; Rep. gr. 27 .
– Insert engine/gearbox unit into the body.
– Initially insert screws -arrows- for engine mount by hand as far
as the stop.
30
Rep. gr.10 - Removing and installing engine
⇒ page 64 .