Skoda Octavia III 2013 Workshop Manual page 173

– Cut off nozzle on tube at front marking (∅ of nozzle approx. 2
mm).
WARNING
Risk of blockage of the lubrication system through excess seal‐
ant.
♦ The sealant bead must not be thicker than specified.
– Apply sealant bead arrow onto the clean sealing surface of the
oil sump top part, as shown in the illustration -arrow-.
♦ Thickness of sealant bead: 2...3 mm.
– Apply silicone sealant, as shown -arrows-, between the cylin‐
der block and the bottom cover for the timing chain.
WARNING
♦ The upper part of the oil sump must be installed within 5
minutes after applying the silicone sealant.
♦ The sealant bead must not be thicker than specified oth‐
erwise excess sealant may get into the oil pan and clog
the strainer in the oil suction pipe.
♦ On the gearbox side, the upper part of the oil sump and
the upper part of the crankcase must connect flush to each
other.
– Immediately fit the upper part of the oil pan and tighten new
screws.
Top part of oil sump - tightening sequence
Stage Screws
1. -1- to -14-
2. -1- and -2-
3. -3- to -9-
4. -10-
5. -11- to -14- turn 90° further
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
Tightening torque/torquing angle
8 Nm
turn 180° further
turn 45° further
turn 180° further
Octavia III 2013 ➤ , Octavia III 2014 ➤
165
1. Sump, oil pump