Removing And Installing The Mpi Injection Valves - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
– The nose -1- and the bore -arrow- in the cylinder head must
coincide.
Note
The injection valve must insert easily, if necessary wait until
♦
the combustion chamber sealing ring has been drawn together
sufficiently.
Pay attention to the correct seating and fitting position of the
♦
injection valves in the cylinder head.
If the injection valve cannot be fitted by hand, push the sleeve
♦
-T10133/18- over the injection valve.
Carefully tap on sleeve several times to loosen the injection
♦
valve.
– Place the support ring on the injection valve.
– Moisten O-rings with clean engine oil.
– Install fuel distributor
– Installing the intake manifold
• Tightening torque: Fuel distributor FSI - Summary of compo‐
nents
⇒ "4.1 Fuel distributor FSI- summary of components",
page 298
4.5 Removing and installing the MPI injec‐
tion valves
Removing
– Remove engine cover
304
Rep. gr.24 - Mixture preparation - injection
⇒ page 299 .
⇒ page 290 .
⇒ page 10 .