Skoda Octavia III 2013 Workshop Manual page 56

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
– Disconnect existing electrical plug connections:
1 - for oil pressure switch - F1- -2-
3 - for oil pressure switch for reduced oil pressure - F378- -4-
5 - for control valve for piston cooling nozzles - N522- -7-
Note
Do not pay attention to the position -6-.
– Remove oil filter element ⇒ Maintenance ; Booklet Octavia
III .
– Release screw -1- of guide pipe for oil dipstick.
Undo guide pipe from the mount on the top cover for the timing
chain -arrow-.
Note
Do not pay attention to the position -2-.
– Expose cable harness.
– Place a catch pan - VAS 6208- under the engine.
– Release screws -1 ... 5- and remove bracket for auxiliary units
from the coolant pump housing.
Install
• Tightening torques ⇒ page 44
Installation is carried out in the reverse order. However, pay at‐
tention to the following:
Note
Replace screws which have been tightened to a torquing an‐
♦
gle.
Replace O-rings and gaskets.
♦
– Moisten O-rings -4- with coolant.
– Insert connecting studs -2- into the thermostat housing -3-.
– Slide bracket for auxiliary units -1- onto the connecting studs,
attach and tighten screws
– Installing AC compressor.
– Install alternator ⇒ Electrical System; Rep. gr. 27 .
– Install poly V-belt ⇒ page 45
– Replenish coolant ⇒ page 182
– Fit oil filter and check the oil level ⇒ Maintenance ; Booklet
Octavia III .
48
Rep. gr.13 - Crankshaft group
⇒ page 44 .
.
.