Removing And Installing N205 / N318 The Camshaft Adjustment Valves; Removing And Installing Top Cover For Timing Chain - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
13 - Sealing ring
❑ for crankshaft V-ribbed belt pulley
❑ replace after removal
14 - Plug
❑ Replace after disassembly
15 - Screw
❑ Replace after disassembly
❑ order of tightening
16 - O-ring
❑ Replace after disassembly
❑ Moisten with oil before installing
17 - Dipstick discharge
18 - Screw
❑ 9 Nm
19 - Inlet camshaft control valve 1 - N205-
1.2 Removing and installing -N205- / -N318-
the camshaft adjustment valves
Removing
– Remove connector -1- from Camshaft control valve 1 in the
exhaust - N318- -2- and connector -3- from Camshaft control
valve 1 - N205- -4-.
– Unscrew screws -arrows- and remove Camshaft control valve
1 - N205- and Camshaft control valve 1 in the exhaust - N318- .
Install
Installation is carried out in the reverse order. However, pay at‐
tention to the following:
• Tightening torques ⇒ page 81
Note
After disassembly, replace gasket rings and O-rings.
– Weat surface of seal in the direction of Camshaft control valve
1 - N205- and Camshaft control valve 1 in the exhaust - N318-
with engine oil.
1.3 Removing and installing top cover for
timing chain
Special tools and workshop equipment required
♦ Hose binding claw - VAS 6362-
♦ Sealant ⇒ ETKA - Electronic Catalogue of Original Parts.
Removing
• Engine cold
82
Rep. gr.15 - Cylinder head, valve gear
⇒ page 89
⇒ page 85