Removing And Installing Coolant Shut-Off Valve N82; Removing And Installing Coolant Shut-Off Valve N82 ", Page - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
– Open heat protection sleeve -3-.
– Unplug connector -1-.
– At the coolant hoses pump - V51- , disconnect coolant hoses
with hose clamps -3094- .
Note
Place a cloth below to absorb leaking coolant.
– Loosen hose clamps -arrows- and remove coolant hoses.
– Unscrew screw -2- and remove coolant recirculation pump -
V51- .
Install
Installation is carried out in the reverse order. However, pay at‐
tention to the following:
Note
Secure all hose connections with hose clamps which comply with
the series design ETKA - ⇒ Electronic Catalogue of Original
Parts .
– Check coolant level
2.8 Removing and installing coolant shut-off
valve - N82-
Special tools and workshop equipment required
♦ Hose clamps up to 25 mm - 3094-
♦ Hose binding claw
Removing
– Remove air filter housing
– Loosen hose clamp -2-.
– Unscrew the screw -1- and press the left-hand air guide pipe
to the left with light force.
198
Rep. gr.19 - Cooling
⇒ page 185 .
⇒ page 288 .