Balancing Shaft Timing Chain- Summary Of Components - Skoda Octavia III 2013 Workshop Manual

– Check the setting; the coloured chain links -arrows- must be
located at the markings of the chain sprockets.
– Screw in and tighten the screws -arrows-.
– Slide in the bearing cap and tighten the screws -arrows- until
hand-tight.
– Remove extractor - T40267- .
– Tighten the screws -arrows- for the bearing cap
– Install the control valves -Pos. 6-
Installation is carried out in the reverse order. When installing,
note the following:
• Tightening torques ⇒ page 90
– Install below cover for timing chain
– Install top cover for timing chain
Carry out an adjustment of the timing chain length as follows:
– Switch on ignition and ⇒ Vehicle diagnostic tester connect.
– On the display press consecutively the following buttons:
♦
01 - Engine electronics
♦
01 - Targeted functions
♦
01 - Basic setting
♦
01 - Adaption after work on chain drive
2.3

Balancing shaft timing chain- Summary of components

1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
⇒ page 90
⇒ page 90 .
⇒ page 85 .
⇒ page 82 .
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
101
2. Chain drive