Skoda Octavia III 2013 Workshop Manual page 70

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
8 - Rotor
❑ For engine speed sender - G28- .
❑ Replace sensor rotor each time the bolts are slackened
❑ assembly only possible in one position -holes offset-
❑ Removing and installing
9 - Thrust washers
❑ for bearing 3
❑ moisten with oil
10 - Screw
❑ Replace after disassembly
❑ order of tightening
Removing and installing sensor rotor
Note
Before removing the crankshaft, ensure a suitable place is avail‐
able for placing it down so that the sensor rotor does not rest on
anything or get damaged.
– Always replace the sensor rotor -2- each time the bolts -1- are
slackened.
Note
After being attached a second time, the attachment point of
♦
the countersunk screws in the sensor rotor is sufficiently mis‐
shapen that the bolt heads rest against the crankshaft -3-
-arrows-. The sensor rotor is positioned loosely underneath
the screws.
It is only possible to install the sensor rotor in one position, the
♦
holes are offset.
Crankshaft - tightening sequence
– Replace all screws for crankshaft and is in the sequence
-1...10- as follows:
1. Tighten the screws -1...10- and -arrows A- hand-tight.
2. Pretension screws -1...10- with 65 Nm.
3. Unscrew screws -1 ... 10Tighten - with the rigid wrench tor‐
1
que by 90° ( / 4 turn).
4. Tighten bolts -arrows A- to 20 Nm.
5.
Tighten -arrows A- with the rigid wrench torque by 90° (
4 turn).
62
Rep. gr.13 - Crankshaft group
⇒ page 62
⇒ page 62
1
/