Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
– Screw out screws -1- and remove connection fitting.
– Unscrew the screws -2 and 3- and remove the oil feed line and
oil return line.
– Unscrew the nuts -arrows-.
– Remove turbocharger from cylinder head and remove up‐
wards.
Install
Installation is carried out in the reverse order. However, pay at‐
tention to the following:
•
Tightening torques
⇒ page 260
Note
After disassembly, replace self-locking nuts, gasket rings and
♦
O-rings.
Coat stud bolts on the turbocharger with Hot bolt paste; Hot
♦
bolt paste ⇒ ETKA - Electronic Catalogue of Original Parts
Fill exhaust turbocharger with engine oil through the connec‐
♦
tion fitting of the oil feed line.
Hose connections and hoses for the charge air system must
♦
be free of oil and grease before being installed.
Secure all hose connections with hose clamps which comply
♦
with the series design ETKA - ⇒ Electronic Catalogue of Orig‐
inal Parts .
– Install exhaust pipe with catalytic converter
– Align exhaust system free of stress
– Replenish coolant
⇒ page 182
– Checking the oil level ⇒ Maintenance ; Booklet Octavia III .
Note
after installing the exhaust turbocharger run the engine approx. 1
minute in idle and do not increase speed immediately in order to
ensure the supply of oil to the turbocharger.
1.3
Removing and installing, adjusting
charge pressure regulator - V465-
Removing
– Remove pre-exhaust pipe with catalytic converter
⇒ page 328
.
266
Rep. gr.21 - Turbocharging/supercharging
⇒ page 328
⇒ page 339
.
.
.