Adjust Charge Pressure Regulator V465 - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
– Screw on charge pressure regulator - V465- -3- with screws
-arrows-.
– Connect the connector -1- to the charge pressure regulator -
V465- .
Set charge pressure regulator - V465- as follows:
– Switch on ignition and ⇒ Vehicle diagnostic tester connect.
– On the display press consecutively the following buttons:
♦
01 - Engine electronics
♦
01 - Targeted functions
♦
01 - Basic setting
♦
01 - Charge pressure regulator - V465 - setting
– Set specified value by adjusting the operating rod; specified
value ⇒ Vehicle diagnostic tester.
– Secure the operating rod with locknut -2-.
– Install exhaust pipe with catalytic converter
1.4 Adjust charge pressure regulator -
V465-
Removing
– Screw out screw -2- and remove camshaft sprocket.
– Unscrew nuts -1 and 3-.
Note
For a clearer illustration, the installation position while the en‐
♦
gine is removed is shown.
Do not pay attention to the position -4-.
♦
– Release screws -arrows-.
Set charge pressure regulator - V465- as follows:
– Switch on ignition and ⇒ Vehicle diagnostic tester connect.
– On the display press consecutively the following buttons:
♦
01 - Engine electronics
♦
01 - Targeted functions
♦
01 - Basic setting
♦
01 - Charge pressure regulator - V465 - setting
– Set specified value by adjusting the operating rod; specified
value ⇒ Vehicle diagnostic tester.
268
Rep. gr.21 - Turbocharging/supercharging
⇒ page 328 .