Removing And Installing Camshafts As Of 07.2013 - Skoda Octavia III 2013 Workshop Manual

– Slide in the bearing cap and tighten the screws -arrows- until
hand-tight.
– Remove extractor - T40267- .
– Tighten the screws -arrows- for the bearing cap
– Install the control valves -Pos. 6-
– Insert the mandrel -T40196- at the positions shown in the
screen.
– Turn the crankshaft in direction of rotation of engine by 4 turns.
– Remove mandrel -T40196- .
– Install top cover for timing chain
Carry out an adjustment of the timing chain length as follows:
– Switch on ignition and ⇒ Vehicle diagnostic tester connect.
– On the display press consecutively the following buttons:
♦
01 - Engine electronics
♦
01 - Targeted functions
♦
01 - Basic setting
♦
01 - Adaption after work on chain drive
Further installation occurs in reverse order.
4.4 removing and installing camshafts as of
07.2013
Special tools and workshop equipment required
♦ Assembly tool - T10352/2-
♦ Counterholder - T10355-
♦ Drift - T40196-
♦ Assembly lever - T40243-
♦ Assembly tool - T40266-
♦ Rig tool - T40267-
♦ Camshaft fixer/locator - T40271-
♦ Assembly tool - T10531-
♦ Protective gloves
♦ Silicone sealant ⇒ ETKA - Electronic catalogue of original
parts
♦ Cleaning and degreasing agent , e.g. -D 009 401 04-
♦ Sealant remover gasket stripper (bearing code GST, bearing
article no. R 34402), manufacturer Retech s.r.o.
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
⇒ page 90
⇒ page 90 .
⇒ page 82 .
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
135
4. Valve gear