Skoda Octavia III 2013 Workshop Manual page 209

– Raise holding clamps -1- and remove the coolant hoses.
Note
Do not pay attention to the position -2-.
– Remove connector -1- from the positioning element for engine
temperature control - N493- .
– Undo screws -1 ... 5-.
– Remove positioning element for engine temperature control -
N493- from the dowel pins and remove from the engine oil
cooler.
Install
Installation is carried out in the reverse order. However, pay at‐
tention to the following:
Note
Replace gaskets and O-rings.
– Wet the O-rings -4- with coolant ⇒ ETKA - Electronic Cata‐
logue of Original Parts .
– Check whether both fitted pins are present in the cylinder
block, insert if necessary.
– Insert connecting piece -2- into the engine oil cooler-1-.
– Insert the positioning element for engine temperature control
- N493- -3- onto the connecting piece and move onto the dowel
pins in the cylinder block.
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
2. Coolant pump and positioning element for engine temperature control
201