Removing And Installing Oil Pressure Switch F1; Removing And Installing Oil Pressure Switch For Reduced Oil Pressure F378 - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
4.3 Removing and installing oil pressure
switch - F1-
Removing
Note
Place cloths under bracket for auxiliary units to catch escaping
coolant.
– Disconnect connector -arrow- from the oil pressure switch -
F1- .
– Screw out oil pressure switch - F1- -1-.
Install
Installation is carried out in the reverse order. However, pay at‐
tention to the following:
• Tightening torques ⇒ page 172
Note
Replace gasket ring.
♦
To prevent oil loss, immediately insert a new oil pressure
♦
switch - F1- into the bore hole.
– Checking the oil level ⇒ Maintenance ; Booklet Octavia III .
4.4 Removing and installing oil pressure
switch for reduced oil pressure - F378-
Removing
Note
Place cloths under bracket for auxiliary units to catch escaping
coolant.
– Remove connector -arrow- from the oil pressure switch for re‐
duced oil pressure - F378- .
– Unscrew the oil pressure switch for reduced oil pressure -
F378- -1-.
Install
Installation is carried out in the reverse order. However, pay at‐
tention to the following:
• Tightening torques ⇒ page 172
Note
Renew seal.
♦
To prevent oil loss, immediately insert a new oil pressure
♦
switch for reduced oil pressure - F378- into the bore hole.
– Checking the oil level ⇒ Maintenance ; Booklet Octavia III .
174
Rep. gr.17 - Lubrication